RDM will use the credentials as configured in the entry properties or the credentials entered in the Management Tools tab. This is slower and requires authentication. If ARP was not successful, another attempt is made using WMI. This is fast and does not require authentication, but there are requirements on the network aspect that may not be met.
The discovery process will initially attempt to use the ARP protocol. If this is unsuccessful, you will need to enter it manually. You can use the Ellipsis button to automatically determine the MAC address.
The input field can be found in the Information tab and in the General child tab. You must add a valid MAC address (Media Access Control address) in the session"s configuration. Your OS must be configured to enable Wake-on-LAN.Your router must be configured to forward broadcast packets.Your power supply must support Wake-on-LAN.Your network card must support Wake-on-LAN.The first step is to verify that your computer supports Wake-on-LAN. Most users do not have to configure their router or worry about this. If you want to wake up a machine on a different subnet, your router must forward UDP port 9, or whatever you change the port assignment to. You can configure which port it uses, the default is 9. WOL broadcasts packets to the target computer over UDP. This means that the sending machine needs to be on the LAN, so we cannot send them over remote IP-based connections, such as over SSH or VPN. The computer must also be in the local area network (LAN) and not connected in a VPN.Īn important thing to note is that Wake-on-LAN operates below the IP level. Plus, the destination motherboard must support it, and it must be enabled. Wake-on-LAN is supported in the Team Edition of Remote Desktop Manager. The target computer sits in a low-power state with only its network card switched on, and when it receives the magic packet, the network card “wakes up” the computer, powering it on and booting it up. This is an OS-agnostic feature that works by broadcasting a specially crafted “magic” packet at the data link layer. Wake-on-LAN is an Ethernet computer networking standard, which allows a computer to be turned on or woken up by a network message.
0 kommentar(er)
